Castle CC011-0132-00 - Rotor / Shaft Replacement Rebuild Kit 1412 series (3.2MM SHAFT)
Overheated your motor? Bent the output shaft? This rotor replacement kit allows you to repair a damaged rotor or shaft. It is easy to replace and contains all of the parts necessary to get your motor back up and running.This kit works with the sensored 1412-2100kv, and 3200Kv motors. It can be used with the 1412-6400kv, but the smaller 3.2mm shaft runs a high risk of snapping in drag applications; broken shafts are not covered by any warranty.
- This motor has the standard 3.2mm output shaft. If you are looking for an upgraded 5mm version, please see part number 011-0158-00.
- If you need a replacement front end bell (shaft side) and bearing, see part number 011-0133-00.
Kit Contains:
- Rotor Assembly - qty 1
- Brass Spacers - qty 2
- Wave Washer - qty 1
Note: This rotor replace is NOT compatible with older sensorless motors. Sensorless motors are easily identifiable by their red, black and white motor wires; sensored motors have all black motor wires.
- Designed and supported in Olathe, Kansas USA.
- Made in China.
For instructions on how to install the replacement rotor, please visit https://www.castlecreations.com/motorrepair
Note: Replacement rotors for 17xx and 20xx series motors are not available. These parts are not serviceable and cannot be repaired or replaced. If the rotor is broken, the shaft is bent, or snapped, the entire motor must be replaced.
